BW MCXL-XWHM-Y-CN MicroClip Series Region Multi-Gas Detector

BW MCXL-XWHM-Y-CN MicroClip Series Region Multi-Gas Detector

BW MCXL-XWHM-Y-CN MicroClip Series Region Multi-Gas Detector

Multi-gas made simple
The slim and compact GasAlertMicroClip XT provides affordable protection from atmospheric hazards. This multi-gas detector offers continuous visual confirmation of detector operation and compliance with the IntelliFlash feature and simple one-button operation offers ultimate ease of use and significantly reduces time spent training the user. The GasAlertMicroClip XT is fully compatible with BW’s MicroDock II automatic
test and calibration system.
Standard Package Contents
·Detector complete with specified sensor(s), stainless steel alligator clip
and concussion-proof housing
·Rechargeable battery
·Wall outlet charging adaptor
·Calibration/test cap and hose
·Manual
·Multi-language CD manual
BW MCXL-XWHM-Y-CN MicroClip Series Region Multi-Gas Detector

BW MCXL-XWHM-Y-CN MicroClip Series Region Multi-Gas Detector

How to Replace a Sensor
1. With detector OFF, use No. 1 Phillips screwdriver to remove 6 screws from back enclosure (E)
2. Lift back enclosure (E) straight up
3. Use No. 1 Phillips screwdriver to remove 2 screws from back of PCB (D)
4. Lift PCB (D) together with battery and sensors (C, G, H, I) straight up
5. Remove sensors (C, G, or H) by sliding out or sensor (I) by pulling straight up from PCB (D)
6. Insert new sensor (C, G, H, I) into PCB (D)
7. Replace PCB (D) and 2 screws and hand-tighten until firm
8. Replace back enclosure (E)
9. Replace 6 screws in back enclosure (E) and hand-tighten until firm

BW MCXL-XWHM-Y-CN MicroClip Series Region Multi-Gas Detector

How to Replace the Sensor Screen
1. With detector OFF, use No. 1 Phillips screwdriver to remove 6 screws from back enclosure (E)
2. Lift back enclosure (E) straight up
3. Use No. 1 Phillips screwdriver to remove 2 screws from back of PCB (D)
4. Lift PCB (D) together with battery and sensors (C, G, H, I) straight up
5. Remove sensor screen (J) from front enclosure (B)
6. Insert new sensor screen (J) into front enclosure (B)
7. Replace PCB (D) and 2 screws and hand-tighten until firm
8. Replace back enclosure (E)
9. Replace 6 screws in back enclosure (E) and hand-tighten until firm